xingchang fan's Album: Wall Photos

Photo 5 of 15 in Wall Photos

Crankshaft bending is one of the faults of the air compressor.
What causes this change? First, the common faults of the air compressor are
introduced, and then the reason why the Air compressor crankshaft bends is discussed in
detail.

Common faults of air compressor:

1. The exhaust temperature of the unit is high (over 110℃), and
the air compressor trips by itself

2. Exhaust temperature of air compressor is lower than normal
(lower than 75℃)

3. The unit has large oil consumption, short lubricating oil
adding period or large oil content in compressed air at the outlet.

4. The compressor capacity is lower than the design value and
the outlet pressure is low.

5. Unit exhaust pressure is too high

6. The unit cannot be started (electrical failure)

Why is the crankshaft of air compressor bent:

1. The gap between the connecting rod bushing and the crankshaft
bushing is too large and is not corrected in time.

2. The clearance of crankshaft lining tile is too small, or the
center line of each crankshaft lining tile is not in a straight line.

3. The connecting rod piston assembly or the balance iron and
flywheel are unbalanced, causing additional inertial force and moment of
inertia, causing large vibration of the compressor unit.

4. The crankshaft has been stored unreasonably for a long
time.

5. The compressor foundation sinks.

If you have any questions about the crankshaft of other air
compressors, please call: https://www.chinaxcfan.com/