Household Product Mould Installation And Adjustment Specificati

  • 1. Mould pre-check:

    After the Household Product Mould(FURNITUREMOULD) is installed on the machine, it should be checked in time to find the quality problem in time, and remove the household product mould after installing the machine. When inspecting the mould fixing template and moving the template separately, pay attention to the direction mark to avoid mould clamping. made a mistake.

    2. The oblique guide mode device:

    When installing household product mould, the two should work closely together and pay attention to safety. If there is a transversely shaped mould, the slider should be placed in the horizontal direction, ie the movable block moves left and right.

    3. Mould fastening:

    When the household product mould positioning ring is placed on the positioning ring seat of the injection moulding machine template, the household product mould is closed at a very slow speed, so that the movable template gently presses the household product mould, and then the pressure plate, the pad must be mounted on the pressure plate. For the workpiece and the platen, 4 pieces need to be installed up and down. When pressing the upper plate, care must be taken to adjust the height of the adjusting screw to the same height as the mould, ie the platen should be flat. If the compression plate is tilted, the mould legs cannot be pressed very tightly. The sides of the platen are not close to the mould to avoid friction and damage the mould of the household product.

    4. The correct ejection distance:

    After tightening the mould of the household product, slowly open the mould until the moving template stops moving back. This is to adjust the direction of the punch to the gap between the ejector plate on the mould and the bottom plate of the movable mould to be no less than 5 mm to avoid damage to the household product mould, but to eject the parts.

    5. Adjustment of the tightness of the closed household product mould:

    In order to avoid overflow and ensure proper ventilation of the cavity, the adjustment of the hydraulic plug-clamping structure is mainly based on visual inspection and experience, ie when the mould of the household product is closed, the toggle is fast and slow, that is to say, not very natural. It is not too reluctant to straighten, and the tightness of closing the mould of household products is just right. For moulds that require mould temperature for household products, household moulds should be turned off after the mould temperature of the household products rises.

    6. Can connect cooling water:

    After opening the cooling water, check for dredging or leakage.

    Click Daily Necessities Mould to learn about more information.